Brother International PT-3600 Users Manual - English and Spanish - Page 94

Ch. 4 Machine Adjustments To change the HALF CUTTER setting: This function allows you to adjust how deep a half cut is cut with laminated tape, for example, if the tape is cut too much or not enough. Normally, it is only necessary to change the setting by one. If the half cut is still either too deep or not deep enough, change the setting by one again. NOTE If the tape is still not cut correctly even after this setting has been continuously adjusted, the cutter may be dull. Contact your service representative. 1 Hold down d and press A. NOTE This step may be skipped if settings for several Setup functions are being applied at the same time. 2 Press j or k until HALF CUTTER is dis- played. R1 2 3 4 5 6 7 8 9 A B C RRRG H RI RJ 06/07 NLMO HALF 00±3 CUTTER AUTO 1.00 HELSINKI D E A F K QQQQQQQQQQQQ AUTO Length Margin Font Width Size 3 Press m or g until the desired setting is displayed. NOTE ☞ To cut less deep, select a lower value. To cut deeper, select a higher value. ☞ Adjust the setting in small steps. ☞ To return the function to its default setting (0), press the space bar. 4 Press n to apply the setting. NOTE To apply several Setup settings at the same time, continue pressing j or k to select the function, then pressing m or g to select the desired setting. Press n only after the necessary functions have been set. To change the USB ID SELECTION setting: This function allows you to specify a unique identification number for each P-touch connected to a computer in order to print through the USB connection. Normally, for easy setup of multiple P-touch machines connected to a computer, all PT-9600/3600s will be set to 000000001, indicating that the data will be printed on all connected P-touch machines at the same time. 1 Hold down d and press A. NOTE This step may be skipped if settings for several Setup functions are being applied at the same time. 2 Press j or k until USB ID SELECTION is displayed. R1 2 3 4 5 6 7 8 9 A B C D E RRRG H RI RJ 07/07 NLMO USB ID SELECTION 000000001 AUTO 1.00 HELSINKI A F K QQQQQQQQQQQQ AUTO Length Margin Font Width Size 3 Press m or g until the desired setting is displayed. NOTE To return the function to its default setting (000000001), press the space bar. 4 Press n to apply the setting. NOTE To apply several Setup settings at the same time, continue pressing j or k to select the function, then pressing m or g to select the desired setting. Press n only after the necessary functions have been set. Machine Adjustments 82