Canon 40MC Elura Instruction Manual - Page 65

Searching the Tape (Photo Search/Date Search) VCR • OFF • VCPROWETR MOVIE • OFF MOVIE P.SCAN • P.SCAN PHOTO PHOTO • E REC PAUSE SEARCH SELECT ZERO SET MEMORY REW PLAY FF AUDIO DUB. - / STOP + / A/V INSERT PAUSE SLOW ×2 Using the Full Range of Features This allows you to move quickly through still pictures recorded anywhere on a tape (photo search) or between different days or areas of recording (date search). • You can only use this function from the wireless controller. 1. Turn the POWER switch to VCR. 2. Press the SEARCH SELECT button to choose between photo/date search. • PHOTO SEARCH or DATE SEARCH is shown in the display for four seconds. 3. Press the - and + buttons to move backwards or forwards through the still pictures or between different days of recording. • Press once to move to the start of the previous/next still picture or day on the tape. • You can press more than once to move to the corresponding still picture or day (up to a maximum of ten times), e.g. press the + button five times to move forward five still pictures or days. • PHOTO SEARCH/DATE SEARCH appears in the middle of the display alongside the - or + mark and number to search through. The recording mode is also shown (SP/LP). Notes: • Press 3 (stop) to stop mid-search. • If you begin a search very close to the start of a recorded still picture during photo search, the camera may skip straight past it. • When you have set the area for the World Clock, date search also looks for the change in date based on the adjusted time. • A date/area cannot be identified if the total recording time on that day/area was less than one minute. • Date search playback may start just before or after the beginning of the located section. • If the data code is not displayed correctly you will not be able to operate the date search correctly. 65