Canon BJC6500 Service Manual - Page 38
Grease Points, 3.8 Grease application points
View all Canon BJC6500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 38 highlights
Part 2: MAINTENANCE BJC-6500 2.3.8 Grease application points Apply greases at the points shown below. Apply a thin film of grease using the flat brush. For the Carriage Oil Pad, do not use a brush but apply directly. For disassembly and reassembly procedures, refer to the parts catalog. CAUTION Do not apply more than the specified amount of grease, especially to the grease pad. If grease gets on the wipers or caps, damage is likely to occur. Cam Sliding Surface Approx. 24 mg (Molykote PG-641) Grease Pad Approx. 0.6 cc (Floil 946P) Cam Sliding Surface Approx. 24 mg (Molykote PG-641) Eject Roller Gear Teeth (apply to all teeth evenly) Approx. 60 mg (Molykote PG-641) Feed Roller Gear Teeth (apply to all teeth evenly) Approx. 96 mg (Molykote PG-641) Carriage Guide Frame Sliding Surface (apply the proper amount of grease so as not to drip) (Floil 946P) Carriage Guide Frame Back Surface (apply a thin coat of grease over the entire surface) Approx. 48 mg (Molykote PG-641) Slow-Down Gear Teeth (apply to all teeth evenly) Approx. 72 mg (Molykote PG-641) Feed Roller Sliding Surface Approx. 12 mg (Molykote PG-641) Feed Roller Sliding Surface Approx. 12 mg (Molykote PG-641) Paper Thickness Lever Sliding Surface Approx. 12 mg (Molykote PG-641) Paper Thickness Lever Spring Sliding Surface Approx. 12 mg (Molykote PG-641) Figure 2-11 Grease Points 2-10