Canon PowerShot G5 Service Manual - Page 78
NOTE1 Assembling, Fig.3-30 Assembling the CCD HOLDER, SHUTTER UNIT-2
View all Canon PowerShot G5 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 78 highlights
CHAPTER 3. REPAIR INSTRUCTION SHUTTER UNIT (1)-1 A FRONT LENS UNIT B NOTE1 (Assembling) (1)-1 (1)-2 LENS BARREL UNIT B CCD HOLDER UNIT Large projected part Dowel (1)-3 FPC GUIDE Flexible board of the SHUTTER UNIT (1)-4 Dowel FPC GUIDE NOTE2 (Assembling) (1)-5 Small projected part (1)-5 Small recepted groove Large recepted groove (1)-6 s s XA4-9170-457 4.5mm METAL M1.7 (SELF TAP) Fig.3-30 Assembling the CCD HOLDER,SHUTTER UNIT-2 2.3.4.3 Assembling the CCD HOLDER, SHUTTER UNIT-2 (1) Assembling the CCD HOLDER,SHUTTER UNIT-2 1. Hold the portion A and rotate it in the direction of the arrow as far as it can go. 2. Rotate the portion B of the LENS BARREL UNIT in the direction of the arrow as far as it can go. 3. Install the FPC GUIDE. 4. Align the SHUTTER UNIT with the dowel used for position setting. 5. Align the large hole and small hole of the receptacle with the large projection and small projection of the projected part, and insert the CCD HOLDER UNIT. 6. Install the three screws of s. NOTE1 (Assembling) When the SHUTTER UNIT is rotated, the portion B of the LENS BARREL UNIT will project. Do not care about the projection and keep rotating it. When it is rotated as far as it can go, the FRONT LENS UNIT enters into the portion B of the LENS BARREL UNIT. NOTE2 (Assembling) When installing, use the original CCD HOLDER UNIT that has been removed from the original OPTICAL UNIT. 3-30