Cisco 3750G-12S Hardware Installation Guide - Page 124
that no exposed portion of the DC-input power source wire extends from the terminal block plug.
UPC - 746320812526
View all Cisco 3750G-12S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 124 highlights
Connecting to DC Power Appendix C Connecting to DC Power Step 5 Insert the exposed wire of one of the four DC-input power source wires into the terminal block plug, as shown in Figure C-7. Make sure that you cannot see any wire lead. Only wire with insulation should extend from the terminal block. Warning An exposed wire lead from a DC-input power source can conduct harmful levels of electricity. Be sure that no exposed portion of the DC-input power source wire extends from the terminal block plug. Statement 122 Figure C-7 Inserting Wires in the Terminal Block Plug Return Negative Return Negative Feed A Feed B 60532 Step 6 Use a ratcheting torque screwdriver to torque the terminal block captive screw (above the installed wire lead) to 4.5 lbf-in. (72 ozf-in.), as shown in Figure C-8. Caution Do not overtorque the terminal-block captive screws. The recommended maximum torque is 4.5 lbf-in. (72 ozf-in.) Catalyst 3750 Switch Hardware Installation Guide C-6 OL-6336-10