Cisco 3750G-12S Hardware Installation Guide - Page 66
Attaching the Brackets to the Switch for Wall-Mounting, Attaching the RPS Connector Cover, - specification
UPC - 746320812526
View all Cisco 3750G-12S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 66 highlights
Installing the Switch Chapter 2 Switch Installation Attaching the Brackets to the Switch for Wall-Mounting Figure 2-41 shows how to attach a 19-inch bracket to one side of the switch. Follow the same steps to attach the second bracket to the opposite side. Figure 2-41 Attaching the 19-inch Brackets for Wall-Mounting 23 24 23X 24X Catalyst 3750 SERIES 25 26 27 28 86687 1 1 Phillips truss-head screws Attaching the RPS Connector Cover If you are not using an RPS with your switch, use the two Phillips pan-head screws to attach the RPS connector cover to the back of the switch, as shown in Figure 2-42. Warning If an RPS is not connected to the switch, install an RPS connector cover on the back of the switch. Statement 265 Figure 2-42 Attaching the RPS Connector Cover on the Switch 86571 STACK 1 STACK 2 CONSOLE [email protected] 1 2 3 1 Phillips pan-head screws 3 RPS connector 2 RPS connector cover 2-28 Catalyst 3750 Switch Hardware Installation Guide OL-6336-10