Cisco 3750G-12S Hardware Installation Guide - Page 131

Appendix D Configuring the Switch with the CLI-Based Setup Program Connecting to the Console Port Connecting to the Console Port You can use the console port to perform the initial configuration. To connect the switch console port to a PC, use the supplied RJ-45-to-DB-9 adapter cable. Note If you have stacked your switches, connect to the console port of one of the switches in the stack. The initial configuration for the entire stack can be performed on any switch in the stack. Follow these steps to connect the PC or terminal to the switch: Step 1 Step 2 Using the supplied RJ-45-to-DB-9 adapter cable, insert the RJ-45 connector into the console port on the rear of a switch, as shown in Figure D-4. Attach the DB-9 female DTE of the adapter cable to a PC serial port, or attach an appropriate adapter to the terminal. Figure D-4 Connecting a Switch to a PC 3 CONSOLE CONSOLE CONSOLE 1.6A-100R>09A-A2T0,IN05GV0-~60 HZ 1.6A-100R>09A-A2T0,IN05GV0-~60 HZ 1.6A-100R>09A-A2T0,IN05GV0-~60 HZ [email protected] [email protected] [email protected] 1 2 90531 1 Catalyst 3750 switches 2 Power cord 3 RJ-45-to-DB-9 adapter cable OL-6336-09 Catalyst 3750 Switch Hardware Installation Guide D-5