Cisco ASR1006-10G-SEC/K9 Installation Guide - Page 23
Connecting Power to the Cisco ASR 1006 Router, Power Cords Supported by the Cisco ASR 1006 Router - training
View all Cisco ASR1006-10G-SEC/K9 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
Chapter 6 Cisco ASR 1006 Router Overview and Installation Connecting Power to the Cisco ASR 1006 Router When in a fixed-speed configuration and MDI mode: • Use a crossover cable to connect to an MDI port • Use a straight-through cable to connect to an MDI-X port Connecting Power to the Cisco ASR 1006 Router Warning The covers are an integral part of the safety design of the product. Do not operate the unit without the covers installed. Statement 1077 Warning When you install the unit, the ground connection must always be made first and disconnected last. Statement 1046 Warning Before performing any of the following procedures, ensure that power is removed from the DC circuit. Statement 1003 Warning Only trained and qualified personnel should be allowed to install, replace, or service this equipment. Statement 1030 This section describes the procedure to connect AC input and DC input power to your Cisco ASR 1006 Router. The DC power supply for the Cisco ASR 1006, ASR 1004, ASR 1002, and ASR 1013 routers operate at individual specifications. Table 6-2 shows the common input ranges and circuit breaker requirements. Table 6-2 Cisco ASR 1000 Series Router DC Power Supply System Input Requirements Cisco ASR 1000 Series Router DC Power Supply System Input Rating (Amps) Circuit Breaker Amps AWG # Wire Minimum Maximum Minimum Maximum Cisco ASR 1006 40 Always 50 Always AWG #6 wire Cisco ASR 1004 24 30 40 10 8 Cisco ASR 1002 16 20 30 12 10 Cisco ASR 1013 40 Always 50 Always AWG #6 wire For example, the Cisco ASR 1002 Router DC power supply, with 16 Amp input rating must use an AWG #12 gauge wire for a 20 A circuit breaker and an AWG #10 gauge wire for a 30 A circuit breaker. Power Cords Supported by the Cisco ASR 1006 Router The following power cords are supported by the Cisco ASR 1006 Router: • CAB-AC20A-90L-IN-20 A AC right-angle power cord-International OL-13208-09 Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation Guide 6-23