Cisco ASR1006-10G-SEC/K9 Installation Guide - Page 3

280029 Chapter 6 Cisco ASR 1006 Router Overview and Installation Cisco ASR 1006 Router Description Rear View Figure 6-2 shows the rear of the Cisco ASR 1006 Router with the ASR1006-PWR-AC power supply installed. Figure 6-2 Cisco ASR 1006 Router Rear View with the AC Power Supply (ASR1006-PWR-AC) 67 8 OUTPUT INPUT INPUT FAIL OK OK ALARMS 60V 1A MAX 100-240V~ 16-7A 5 50-60HZ This unit might have more than one power supply connection. All connections must be removed to de-energize the unit. 4 3 2 1 1 AC power supply fan 5 AC power supply handle 2 AC power supply DB-25 alarm connector-A 6 AC power inlet female DB-25 sub connector which enables you to attach an external alarm monitoring facility to the router, thus supporting a telco-style of handling alarm conditions in the router. For a description of the DB-25 alarm connector, see the "How Cisco ASR1000-RP Alarm Monitoring Works" section on page 2-21. 3 Cable tie wrap tabs 7 AC power supply Standby switch. A Standby switch is not considered a disconnect. 4 AC power supply captive screws 8 AC power supply LEDs Internal fans draw cooling air into the chassis and across internal components to maintain an acceptable operating temperature. (See Figure 6-2.) The fans are located at the rear of the chassis. A two-hole grounding lug is located on the side of the chassis. Two power supplies, either two AC power supplies or two DC power supplies, are accessed from the rear of the router. Note You have already unpacked your chassis and read all the site requirements for your new equipment. Proceed with the installation. Note Do not combine AC and DC power supplies in the same chassis. OL-13208-09 Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation Guide 6-3