Cisco WS-C4003-RF Hardware Maintenance Manual - Page 61
Making Ethernet Connections, In the configuration on the left
View all Cisco WS-C4003-RF manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 61 highlights
Making Network Connections Making Ethernet Connections Ethernet network processor modules contain both Ethernet AUI connectors and 10BaseT connectors. Dual Ethernet modules contain two of each type of connector interface. For dual-port Ethernet modules (see Figure 3-2), connect either the Ethernet AUI connector or the 10BaseT connector on a specific Ethernet port, but not both connectors on the same port. For single-port Ethernet modules (see Figure 3-3), connect either the Ethernet AUI or the 10BaseT connector, but not both on the same module. In Figure 3-2, the configuration on the left, showing two network connections attached to Port 0, is unsupported; the configuration on the right, which shows two network connections, one to Port 0 and one to Port 1, is supported. Figure 3-2 Making Dual-Ethernet Module Network Connections Unsupported configuration Ethernet module AUI AUI AUI Router AUI (rear view) H1571a AUX 10BaseT cable AUX to transceiver Slide-latch Ethernet transition connector cable to transceiver In Figure 3-3, the single-port Ethernet module on the left shows an unsupported configuration of two network connections going to two connectors on the same port; the module on the right shows a supported connection with a single 10BaseT cable connecting to a single connector on the port. Figure 3-3 Unsupported and Supported Single-Port Ethernet Module Connections Unsupported configuration Ethernet module H1570a AUI 10BASE-T AUX Router (rear view) AUI 10BASE T AUX 10BaseT cable to transceiver Installing the Router 3-3