Compaq ProLiant 1000 Migrating to Microsoft Windows NT Server 4.0 on Compaq Se - Page 23

467A/0197 WHITE PAPER (cont.) ... 22. After you log on the first time in the Windows NT 4.0 environment, several error messages might display. The following table lists these messages and comments about them: Error Messages Comments SNMP.EXE unable to locate SNMPAPI.DLL in specified path The SNMP error only occurs if you previously installed SNMP. DHCP Server will now terminate because existent database needs conversion to Windows NT SVR format. DHCP will auto start after conversion. The DHCP error only occurs if you previously installed DHCP. WINS can not come up because it needs conversion to Windows NT SVR format. Click OK to terminate WINS, WINS will auto start after conversion. The WINS error only occurs if you previously installed WINS. Service Control Manager states that at least one service or driver failed during start-up. There can be multiple causes of this error message, check the event viewer or log under Administration Tools and correct any issues that might have been overlooked. 23. Install SSD 1.20, or later, select Express, update all the necessary components, and reboot the server. 24. Remove the SNMP Service. From the Control Panel icon, select the NETWORK applet, select the Services tab (next to the Identification tab), double click on the SNMP Service, follow the instructions. Re-install the SNMP Service. Reboot the Server. 25. Reboot the server. 26. Re-install the Compaq Insight Manager Agents (version 3.10 or higher), if they were previously installed, from the Compaq System Manager CD. Select Update to load the latest version of the Compaq Insight Manager Agents. Reboot the computer or server. If you choose to re-install a pre-existing version, remove the Agents before re-installing. NOTE: Always install the Compaq SSD program and reboot the server before installing the Compaq Insight Manager Agents. 27. You can optionally install Microsoft Service Pack 2. 28. Your upgrade should be complete. However, check the Event Viewer for additional information. Upgrading the Compaq Insight Management Agents The procedures that follow outline the necessary steps to update your system with the Compaq Insight Management Agents 3.10 or later software. From the Windows My Computer applet, perform the following steps: 1. Insert the Insight Agent Setup CD into your CD-ROM drive. 2. Locate the Agent directory, (the path is x:\agents\win-nt\eng\setup.cmd; where x is the CD-ROM drive letter) then locate the Windows NT directory, then choose the setup.cmd or setup.exe. 3. Select Continue at the Insight Agents Setup screen. 23