Dell E6500 Service Manual - Page 43

Back to Contents Page Optical Drive Dell™ Latitude™ E6500 Service Manual Removing the Optical Drive Replacing the Optical Drive The optical drive bay supports either an optical drive, a second hard drive, or an air bay for travel. Removing the Optical Drive Before working inside your computer, read the safety information that shipped with your computer. For additional safety best practices information, see the Regulatory Compliance Homepage at: www.dell.com/regulatory_compliance. NOTE: The optical drive security screw is optional and may not be installed on your computer. 1. Follow the procedures in Before Working on Your Computer. 2. Close the display and turn the computer over. 3. Remove the bottom of the base assembly (see Removing the Bottom of the Base Assembly). 4. If a security screw is in place, remove it from the drive. 5. Push the drive lever in to release it. 6. Pull the drive out of the optical bay. 1 media bay 2 optical drive 3 drive lever 4 security screw (optional) Replacing the Optical Drive Before working inside your computer, read the safety information that shipped with your computer. For additional safety best practices information, see the Regulatory Compliance Homepage at: www.dell.com/regulatory_compliance. NOTE: The optical drive security screw is optional and may not be installed on your computer. 1. Slide the drive in the optical bay. 2. Push the release latch in to secure the drive. 3. If a security screw was removed, replace the security screw. 4. Replace the bottom of the base assembly (see Replacing the Bottom of the Base Assembly). 5. Replace the battery (see Replacing the Battery). Back to Contents Page