Dell PowerConnect Brocade 300 Fabric OS Administrator's Guide v7.1.0 - Page 348

12 Traffic Isolation Zoning overview • Ensure that there are multiple paths between switches. Disabling failover locks the specified route so that only TI zone traffic can use it. Non-TI zone traffic is excluded from using the dedicated path. • You should enable failover-enabled TI zones before enabling failover-disabled TI zones, to avoid dropped frames. When you issue the cfgEnable command to enable the zone configuration, if you have failover disabled zones, do the following: 1. Temporarily change failover-disabled TI zones to failover-enabled. 2. Enable the zones (cfgEnable). 3. Reset all the zones you changed in step 1 to failover-disabled. 4. Enable the zones again (cfgEnable). These steps are listed in the procedures in this section. • It is recommended that TI zone definitions and regular zone definitions match. • Domain controller frames can use any path between switches. Disabling failover does not affect Domain Controller connectivity. For example, in Figure 32, if failover is disabled, Domain 2 can continue to send domain controller frames to Domain 3 and 4, even though the path between Domain 1 and Domain 3 is a dedicated path. Domain controller frames include zone updates and name server queries. Domain 1 8 1 9 3 Domain 3 9 12 15 7 = Dedicated Path 6 = Ports in the TI zone 5 Domain 2 Domain 4 FIGURE 32 Fabric incorrectly configured for TI zone with failover disabled • It is recommended that the insistent Domain ID feature be enabled; if a switch changes its active domain ID, the route is broken. See the configure command in the Fabric OS Command Reference for information about setting insistent Domain ID. 348 Fabric OS Administrator's Guide 53-1002745-02