Dell PowerConnect Brocade 300 Fabric OS Administrator's Guide v7.1.0 - Page 372

12 Setting up TI over FCR (sample procedure) The Fabric has 3 switches b. Enter the following commands to create and display a TI zone: E1switch:admin> zone --create -t ti TI_Zone1 -p "4,8; 4,5, 1,-1; 6,-1" E1switch:admin> zone --show Defined TI zone configuration: TI Zone Name: TI_Zone1 Port List: 4,8; 4,5; 1,-1; 6,-1 Status: Activated Failover: Enabled c. Enter the following commands to reactivate your current effective configuration and enforce the TI zones. E1switch:admin> cfgactvshow Effective configuration: cfg: cfg_TI zone: lsan_t_i_TI_Zone1 10:00:00:00:00:00:02:00:00 10:00:00:00:00:00:03:00:00 10:00:00:00:00:00:08:00:00 E1switch:admin> cfgenable cfg_TI You are about to enable a new zoning configuration. This action will replace the old zoning configuration with the current configuration selected. If the update includes changes to one or more traffic isolation zones, the update may result in localized disruption to traffic on ports associated with the traffic isolation zone changes Do you want to enable 'cfg_TI' configuration (yes, y, no, n): [no] y zone config "cfg_TI" is in effect Updating flash ... 3. Log in to the edge fabric 2 and set up the TI zone. a. Enter the fabricShow command to display the switches in the fabric. From the output, you can determine the front and translate domains. E2switch:admin> fabricshow Switch ID Worldwide Name Enet IP Addr FC IP Addr Name 1: fffc01 50:00:51:e3:95:36:7e:09 0.0.0.0 0.0.0.0 "fcr_fd_1" 4: fffc04 50:00:51:e3:95:48:9f:a1 0.0.0.0 0.0.0.0 "fcr_xd_6_9" 9: fffc09 10:00:00:05:1e:40:f0:7d 10.32.72.9 0.0.0.0 >"E2switch" The Fabric has 3 switches b. Enter the following commands to create and display a TI zone: E2switch:admin> zone --create -t ti TI_Zone1 -p "9,2; 9,3; 9,6; 1,-1; 4,-1" E2switch:admin> zone --show Defined TI zone configuration: TI Zone Name: TI_Zone1 Port List: 9,2; 9,3; 9,6; 1,-1; 4,-1 Status: Activated Failover: Enabled 372 Fabric OS Administrator's Guide 53-1002745-02