Dell PowerConnect Brocade 300 Fabric OS Administrator's Guide v7.1.0 - Page 550

22 Enabling the DCC policy on a trunk area switch:admin> portdisable 0-2 switch:admin> porttrunkarea --disable 0-2 Trunk index 2 disabled for ports 0, 1, and 2. Enabling the DCC policy on a trunk area After you assign a trunk area, the portTrunkArea command checks whether there are any active DCC policies on the port with the index TA, and then issues a warning to add all the device WWNs to the existing DCC policy with index as TA. All DCC policies that refer to an index that no longer exists will not be in effect. 1. Add the WWN of all the devices to the DCC policy against the TA. 2. Enter the secPolicyActivate command to activate the DCC policy. In order for security to enforce the DCC policy on the trunk ports, you must enable the TA before issuing the secPolicyActivate command. 3. Turn on the trunk ports. Turn on trunk ports after issuing the secPolicyActivate command, to prevent the ports from becoming disabled in case there is a DCC security policy violation. You can configure authentication on all Brocade trunking configurations. For more information on authentication, see Chapter 7, "Configuring Security Policies". Trunking with TI zones See "Trunking with TI zones" on page 359 for details on this topic. 550 Fabric OS Administrator's Guide 53-1002745-02