Dell PowerEdge T320 Owner's Manual - Page 108
Removing and Installing the Control-Panel Assembly in a Rack-Mode System
View all Dell PowerEdge T320 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 108 highlights
Figure 58. Removing and Installing the Control-Panel Assembly in a Rack-Mode System 1. LCD module ZIF connector 2. VGA module connector 3. VGA module cable connector 4. control-panel assembly connector 5. control-panel assembly cable connector 6. screw 7. control-panel board 8. VGA module 9. control panel for rack mode 7. If you are replacing the control-panel assembly, remove the information tag by following the steps below: a) Locate the tabs on the information tag. b) Use a flat screwdriver to press the tabs on the tag one at a time. c) Pull the information tag out of the slot to remove it from the control-panel assembly. NOTE: Retain the information tag for replacement in the new control-panel assembly. Figure 59. Removing and Installing the Information Tag 1. information tag 2. tabs (2) 108