Fluke Ti55FT-20 User Manual - Page 57
Adjusting IR-VL IR-Fusion® Blend Level, High Brightness, Vivid Color
View all Fluke Ti55FT-20 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 57 highlights
5 Visible Light Camera Module (VLCM) Using Torch Control 1. Tap F. 2. Use the mouse controller to position the pointer over Camera Settings on the popup menu and tap E. 3. Position the pointer over the VLCM tab and tap E. You may need to position the pointer over the right or left arrow and tap E to scroll to the VLCM tab. 4. Position the pointer over the High Brightness box; tap E to add or remove a check mark. A check mark indicates the function is enabled. 5. Position the pointer over the Vivid Color box; tap E to add or remove a check mark. A check mark indicates the function is enabled. 6. Tap to accept setting change and return to scan target mode. Using Torch Control When working in darker areas, you can enable the torch function to provide better lighting. If the flash is not enabled, but the torch function is, the torch remains on during image capture. The torch operates at approximately 50% power continuously; the flash operates at full power the instant the image is captured. Note The torch can be enabled at the same time the flash is enabled. If both functions are enabled, the torch operates continuously, while the flash comes on during the image capture. The torch enabled function times out after 60 seconds. Limit torch use to save battery power. Assign the Torch function to a programmable button (see Chapter 2). Then, to cycle between torch on and torch off, tap A,B, or C as needed. Using Visible Light Flash When working in darker areas, you can enable the flash function to light the target object and capture better-quality visible light images. When the flash is enabled, it operates with one burst of light when an image is captured (the moment the image is paused). 5-5