Fluke Ti55FT-20 User Manual - Page 61
Using Laser Pointer, Enable Onscreen Alarm
View all Fluke Ti55FT-20 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 61 highlights
5 Visible Light Camera Module (VLCM) Using Color Alarms 4. Position the pointer over the Enable Onscreen Alarm box; tap E to add or remove a check mark. A check mark indicates the function is enabled. 5. Tap to accept setting change and return to scan target mode. To set color alarms for temperatures either inside or outside of the specified temperature range: 6. Follow steps 1-4. 7. Position the pointer over the "Temperatures Are Inside Specified Range" checkbox; tap E. A check mark indicates that temperatures within the range will be used. 8. If you have selected "Alarm Outside Range," position the pointer over the Max or Min box as desired; tap E to add or remove a check mark. A check mark indicates the function is enabled. If you selected "Temperatures are Inside Specified Range," you cannot change the Max or Min check boxes. 9. Continue to Step 10 to set the alarm temperature range, or go to Step 12 if finished. To set color alarm temperature range (maximum and minimum temperatures): 10. Follow steps 1-4. 11. You can increase or decrease values rapidly to get near the value you want: • Position the pointer over either the Max or Min temperature value; tap E; the box becomes highlighted. Use the mouse controller up/down action to quickly adjust the value in large increments. Tap E again to enter the selected value. • Increase or decrease values slowly one digit at a time to hit the exact value you want, position the mouse pointer over the value's corresponding right/left arrows, then tap E as needed until you reach value you want. 12. Tap to accept setting change and return to scan target mode. Using Palette Bar to Adjust Color Alarm Ranges If you have enabled color alarms, the color alarm temperature limits are indicated next to the color palette on the display screen. 5-9