Garmin GPSMAP 276C Owner's Manual - Page 112
Connecting Your GPSMAP 276C to a Computer, To connect your GPS to your computer - drivers
UPC - 753759044138
View all Garmin GPSMAP 276C manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 112 highlights
Appendix > Installation Information Connecting Your GPSMAP 276C to a Computer You can connect your GPSMAP 276C to your computer using the supplied USB cable to connect to a USB data port or the optional PC Interface cable to connect to a DB-9 serial communications port. Note: Fully install the supplied MapSource program, Trip & Waypoint Manager, on your computer before connecting the USB cable to the computer. USB connector under weather cap USB Data Port on Your PC Serial Communications Port To connect your GPS to your computer: 1. Connect the small end of your cable to the lower connector on the back of the GPSMAP 276C, shown in the illustration to the left. 2. When using the supplied USB Data Cable, connect the larger end of the cable to an available USB data port (see the illustration on the left). When using a computer Interface Cable, connect the larger end of the cable to a serial communications port on your computer (see illustration on the bottom left). Information About USB Drivers The USB drivers should have been automatically installed when you installed the MapSource program that came with your GPSMAP 276C. When you initially connect the GPSMAP 276C to a USB port, your computer might prompt you to locate the destination of the drivers for the device. You only need to install the drivers once. After the drivers are installed, your computer always detects your GPSMAP 276C when it is connected. USB drivers might be updated periodically. You can find these updates at www.garmin.com. 104 GPSMAP 276C Owner's Manual