Hayward OmniLogic Operation Manual - Page 29

Web Enabled Control The OmniLogic should have already been configured for use with the home's router to allow for remote control through the web. This procedure is covered in the Configuration Wizard information found in the Installation Manual. After configuration, an account must be created to allow access to the OmniLogic from web enabled devices. If this has not already been done by the installer, follow the procedure below. 1) Using an ordinary web browser, go to www.haywardomnilogic.com. If you don't already have an account, select "Register New User" and set up a new account. 2) Log in to your account. 3) Register your OmniLogic. While filling out the form to register your OmniLogic, you'll be asked for an MSP System ID. This number can be found directly from the OmniLogic. To find your unit's MSP ID, follow the procedure below: MSP ID___________ msp id:3233 component MSP MP Relays firEmcowSatraer uppugmrpade EccoonSftiagrwpiuzmarpd HUA version 0-0-0-0 X.1.0.118-b14005 1-65-0-2a-d4 R.1.0.2 3-10-0-0-1 10-0-r0e-s0t-o4ree config R.1.0.2 R.3.0.4 10-0-0s-y0s-t5e4m info R.3.0.4 display ScoYnSfTigEuMrationweb server backup config wired networking ºF PcoOnOhfLiegautriantgion themes favorites config ºF alarm lights daylight features After the MSP is accepted, the OmniLogic will be linked to your account. You'll be able to access the OmniLogic at any time from your browser by logging into your account at haywardomnilogic.com. For mobile devices, an application must be downloaded from your device's app store. Go to www.hayward.com for more information on the availability and function of mobile apps. 29 USE ONLY HAYWARD GENUINE REPLACEMENT PARTS