HP 4400 HP StorageWorks Fabric OS 6.4.1 Release Notes (5697-0760, November 201 - Page 63
Workaround prior to upgrade, Active=Save Mode, Edit CUP Port, Connectivity Configuration
View all HP 4400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 63 highlights
Closed defect summary Solution When Access Gateway switch is connecting to a secondary port on an 8Gb or 4Gb 48-port blade, if the primary port goes down, some frames may be wrongly routed to the Access Gateway switch's secondary port, and AG will respond to these frames with ACC rather than drop. Fixed in Fabric OS 6.4.0 Workaround prior to upgrade: Do not put AG switch at the secondary port on 48-port blades. Misleading error when attempting to set port name field on port 255 Fixed in Fabric OS 6.4.0 (unsupported port). With HP StorageWorks 4/8 and 4/16 SAN Switches, and 4Gb BladeSystem switches for p-Class and c-Class BladeSystem, speed negotiation fails when the port is locked as G_Port, and port cannot come online. Fixed in Fabric OS 6.4.0 In a multi-circuit FCIP tunnel configuration with 1606 Extension SAN switch, or multiprotocol extension blade, circuit failover on 1 Gb tunnels may not fail over to other available circuits with two rate limited circuits. Fixed in Fabric OS 6.4.0 Workaround prior to upgrade: Disable ARL configuration (use minrate and maxrate options on the tunnel and circuit create commands where minrate and maxrate are the same values. Observed VE tunnel bounce after a hareboot on edge switch EX/VEX_Port (Integrated Routing) under heavy load. This is due to fspftimeout during hafailover resulting from neighbor switch disabling the port caused by the switch taking too long to recover. Fixed in Fabric OS 6.4.0 The sfpshow command displays incorrect information for static values Fixed in Fabric OS 6.4.0 of XFPs. Running Fabric OS commands on the default switch with virtual fabrics enabled, after performing multiple cfgenable commands with TI zones enabled, causes a No space left on device error, and no further Fabric OS commands can be executed. Fixed in Fabric OS 6.4.0 Enhancement to the firmware to have an easy single command to know Fixed in Fabric OS 6.4.0 the state of the encryption status. Unable to activate a new PDCM Matrix with Web Tools. Fixed in Fabric OS 6.4.0 Workaround prior to upgrade: Activate the same PDCM Matrix from Web Tools, with Active=Save Mode checked from Edit CUP Port Connectivity Configuration window. I2C read values of 0xFF and I2C NACK error case not properly handled, causing Fabric Watch to report improbable/unpredictable SFP values. Fixed in Fabric OS 6.4.0 Multicast data traffic is not forwarded out of snooping multiprotocol router port. Fixed in Fabric OS 6.4.0 The ipAdEntIfIndex values@ 1.3.6.1.2.1.4.20.1.2 must correspond to Fixed in Fabric OS 6.4.0 ifIndex values at 1.3.6.1.2.1.2.2.1.1. Fabric Watch reports that the switch is in Marginal status due to mar- Fixed in Fabric OS 6.4.0 ginal ports when no ports report errors. HP StorageWorks Fabric OS 6.4.1 Release Notes 63