HP 4400 HP StorageWorks Fabric OS 6.4.1 Release Notes (5697-0760, November 201 - Page 68
Switch does not broadcast Unsolicited FIP Discovery Advertisements. If, HA State syn
View all HP 4400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 68 highlights
Closed defect summary Solution In a large fabric with more than 56 switches, edge DC SAN Backbone Director panics while doing switchdisable; agshow; switchenable loop with AG device, due to termination of msd during fabric reconfiguration. Fixed in Fabric OS 6.4.0 When the haSyncStart command is executed, the HA State synchronization has started message is not displayed. Fixed in Fabric OS 6.4.0 Workaround prior to upgrade: These are just info/display messages. No workaround is necessary. Run hashow to check the status of ha following hasyncstart or hasyncstop. Detected termination of process 0.weblinker.fcg:5110 after enabling Fixed in Fabric OS 6.4.0 port fencing for all E_Ports and F_Ports on the SAN when using DCFM. VE-port/FWconfigure utilization is above 100%, leading to RAS log showing more than 100% utilization. Fixed in Fabric OS 6.4.0 fcipLinkRemfcipEntityWWN of fcipLinkTable do not return the Remote WWN configured. You will not get the remote WWN configured for the fcip tunnel when queried through SNMP. Fixed in Fabric OS 6.4.0 Under certain conditions, after fcoe --disable followed Fixed in Fabric OS 6.4.0 by fcoe --enable , the CNA port WWN appears on fcoe --loginshow but may not appear in nsshow. On stress to fail test, the lisl ports on a logical switch may get stuck in G_Port state after the test of repeated switchdisable/enable commands on the logical switch, followed by hafailover. Fixed in Fabric OS 6.4.0 Workaround prior to upgrade: Use switchdisable/enable on the affected logical switch.. Clean up printf to eliminate error and error message: ssnGet: Unable Fixed in Fabric OS 6.4.0 to get WWN info.sw=0 rc=-5. Adding UNIX "sleep" command to admin commands. Fixed in Fabric OS 6.4.0 Workaround prior to upgrade: Use other roles to accomplish. The supportsave command shows duplicate cmds output for same Fixed in Fabric OS 6.4.0 LS switches. Port admin screen in Web Tools gets switch not reachable error Fixed in Fabric OS 6.4.0 with return of [WARNING - NOT VIRUS SCANNED] for 1 logical switch. Switch does not broadcast Unsolicited FIP Discovery Advertisements. If the CNA expects UAs from the FCF even if the solicited advertisement had the D bit set, it will logout of the FCF after about 20 seconds. Fixed in Fabric OS 6.4.0 Zone-1004 messages seen with port changing from Hard to Session based zoning. When trapped frames get forwarded to the NameServer for zone check, the switch generates a zone-1004 for all trapped frames, whether the port is already in session or hard-based zoning, due to the port being momentarily switched to hard-based zoning when processing the ELS frame that is forwarded to the NS for zone check. Fixed in Fabric OS 6.4.0 68