HP 6400/8400 HP StorageWorks 6400/8400 Enterprise Virtual Array User Guide - Page 95
Table 21 Error Messages, continued
View all HP 6400/8400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 95 highlights
Table 21 Error Messages (continued) Status Code Value 12 Invalid Parameter handle Meaning How to Correct The supplied handle is invalid. This can indicate a user error, program error, or a storage cell in an uninitialized state. In the following cases, the storage cell is in an uninitialized state, but no action is required: Storage cell discard (informational message): Storage cell look up object count (informational message): Storage cell look up object (informational message): In the following cases, the message can occur because the operation is not allowed when the storage cell is in an uninitialized state. If you see these messages, initialize the storage cell and retry the operation. Storage cell set device addition policy Storage cell set name Storage cell set time Storage cell set volume replacement delay Storage cell free command lock Storage cell set console lun id 13 Invalid Parameter Id 14 Invalid Quorum Configuration 15 Invalid Target Handle The supplied identifier is invalid. This can Report the error to product support. indicate a user or program error. Quorum disks from multiple storage systems Report the error to product support. are present. The supplied target handle is invalid. This can indicate a user or program error (Case 1), or Volume set requested usage (Case 2): The operation could not be completed because the disk has never belonged to a disk group and therefore cannot be added to a disk group. Case 1: Report the error to product support. Case 2: To add additional capacity to the disk group, use the management software to add disks by count or capacity. 16 Invalid Target Id 17 Invalid Time 18 Media is Inaccessible 19 No Fibre Channel Port 20 No Image 21 No Permission 22 Storage system not initialized 23 Not a Loop Port 24 Not a Participating Controller The supplied target identifier is invalid. This Report the error to product support. can indicate a user or program error. The time value specified is invalid. This can Report the error to product support. indicate a user or program error. The operation could not be completed Report the error to product support. because one or more of the disk media was inaccessible. The Fibre Channel port specified is not valid. Report the error to product support. This can indicate a user or program error. There is no firmware image stored for the Report the error to product support. specified image number. The disk device is not in a state to allow the The disk device must be in either specified operation. maintenance mode or in a reserved state for the specified operation to proceed. The operation requires a storage cell to exist. Create a storage cell and retry the operation. The Fibre Channel port specified is either not a loop port or is invalid. This can indicate a user or program error. Report the error to product support. The controller must be participating in the storage cell to perform the operation. Verify that the controller is a participating member of the storage cell. 95