HP BL10e HP ProLiant BL e-Class System Maintenance and Service Guide - Page 37
Enclosure Status Assembly, Removing the Integrated Administrator module
UPC - 808736933599
View all HP BL10e manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 37 highlights
Removal and Replacement Procedures 5. Remove both hot-plug power supplies. See the "Hot-Plug Power Supplies" section in this chapter. 6. Remove the interconnect tray from the enclosure. See the "Interconnect Tray" section in this chapter. 7. Rotate the quarter-turn posts on the Integrated Administrator module 90 degrees (1). 8. Remove the two screw locks with the tool provided in the spares kit (2). 9. Lift the Integrated Administrator module off the anchor pins (3). 10. Remove the Integrated Administrator module from the interconnect tray (4). Figure 2-16: Removing the Integrated Administrator module from the interconnect tray Reverse steps 1 through 10 to replace the Integrated Administrator module. Enclosure Status Assembly To remove the enclosure status assembly: 1. Power down each server blade. See the "Powering Down a Server Blade" section in this chapter. 2. Power down the enclosure. See the "Powering Down the Enclosure" section in this chapter. 3. Disconnect all cables and power cords from the AC power source. 4. Disconnect all cables and power cords from the enclosure rear panel. 5. Remove all server blades and server blade blanks. See the "Removing a Server Blade" and the "Removing a Server Blade Blank" sections in this chapter. 2-22 HP ProLiant BL e-Class System Maintenance and Service Guide HP CONFIDENTIAL Codename: MacDuff Part Number: 249066-005 Last Saved On: 7/11/03 7:27 AM