HP DL360 HP ProLiant DL360 Generation 3 Server Maintenance and Service Guide - Page 35
PCI Riser Board Assembly, Replacing an Expansion Board
UPC - 613326948835
View all HP DL360 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 35 highlights
Removal and Replacement Procedures 4. Connect the power cord. PCI Riser Board Assembly The procedures in this section assume that the server is configured with two PCI riser board assemblies. To remove the PCI riser board assembly: 1. Power down the server. Refer to "Powering Down the Server" earlier in this chapter. 2. Remove the server from the rack. Refer to "Removing the Server from the Rack" earlier in this chapter. 3. Remove the access panel. Refer to "Server Access Panel" earlier in this chapter. 4. Loosen the PCI riser board thumbscrew (1). 5. Lift the front of the assembly slightly (2), and then pull it out from the server chassis PCI expansion board slot (3). Figure 2-23: Removing the PCI riser board assembly Reverse steps 1 through 5 to replace the PCI riser board assembly. Replacing an Expansion Board To replace an expansion board: 1. Power down the server. Refer to "Powering Down the Server" earlier in this chapter. 2. Remove the server from the rack. Refer to "Removing the Server from the Rack" earlier in this chapter. 3. Remove the access panel. Refer to "Server Access Panel" earlier in this chapter. 2-22 HP ProLiant DL360 Generation 3 Server Maintenance and Service Guide HP CONFIDENTIAL Codename: M-ERTL Part Number: 293948-003 Last Saved On: 9/18/03 9:30 AM