HP DL360 HP ProLiant DL360 Generation 3 Server Maintenance and Service Guide - Page 51
Processor Power Module, Installing the heatsink onto the processor and closing
UPC - 613326948835
View all HP DL360 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 51 highlights
Removal and Replacement Procedures 4. Install the heatsink (1). CAUTION: Before closing the heatsink retaining clip, be sure the processor socket locking lever is closed. Do not force the lever closed; it should close without resistance. Forcing the lever closed may result in damage to the processor socket, requiring replacement of the system board. 5. Close the processor heatsink retaining clips (2). Figure 2-43: Installing the heatsink onto the processor and closing the locking latches Processor Power Module Each processor has an associated PPM. Figure 2-38 shows the location of the processors and PPMs on the system board. To replace a PPM: 1. Power down the server. Refer to "Powering Down the Server" earlier in this chapter. 2. Remove the server from the rack. Refer to "Removing the Server from the Rack" earlier in this chapter. 3. Remove the access panel. Refer to "Server Access Panel" earlier in this chapter. 2-38 HP ProLiant DL360 Generation 3 Server Maintenance and Service Guide HP CONFIDENTIAL Codename: M-ERTL Part Number: 293948-003 Last Saved On: 9/18/03 9:30 AM