HP DL360 ProLiant DL360 Generation 3 Server Maintenance and Service Guide - Page 35
I/O System Fan Assembly, Disconnecting cables from the optical device/diskette
UPC - 613326948835
View all HP DL360 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 35 highlights
Removal and Replacement Procedures I/O System Fan Assembly To remove the I/O system fan assembly: 1. Power down the server. Refer to "Powering Down the Server" earlier in this chapter. 2. Remove the server from the rack. Refer to "Removing the Server from the Rack" earlier in this chapter. 3. Remove the access panel. Refer to "Server Access Panel" earlier in this chapter. 4. Remove the PCI riser board assembly. Refer to "PCI Riser Board Assembly" earlier in this chapter. 5. Disconnect the fan power cables from the optical device/diskette drive interface board (1). 6. Disconnect the optical device/diskette drive interface board power cable from the optical device/diskette drive interface board (2). 7. Remove the optical device/diskette drive interface board power cable from the clip on the side of the I/O fan assembly (3). Figure 2-26: Disconnecting cables from the optical device/diskette drive interface board 2-24 HP ProLiant DL360 Generation 3 Server Maintenance and Service Guide HP CONFIDENTIAL Codename: Introv-ERTL Part Number: 293948-005 Last Saved On: 2/27/04 2:49 PM