HP Mini CQ10-100 Compaq Mini CQ10 Notebook PC - Maintenance and Service Guide - Page 54
Remove the 8 Phillips PM2.5×6.0 screws, Release the ZIF connector
View all HP Mini CQ10-100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 54 highlights
6. Remove the 8 Phillips PM2.5×6.0 screws that secure the top cover to the base enclosure. 7. Lift the inside edge of the top cover (1) and swing it up. Then slide the top cover back slightly to rest against the display assembly (2) at an angle. 8. Release the ZIF connector (1) to which the TouchPad button board cable is connected. 46 Chapter 4 Removal and replacement procedures
6.
Remove the 8 Phillips PM2.5×6.0 screws
that secure the top cover to the base enclosure.
7.
Lift the inside edge of the top cover
(1)
and swing it up. Then slide the top cover back slightly to
rest against the display assembly
(2)
at an angle.
8.
Release the ZIF connector
(1)
to which the TouchPad button board cable is connected.
46
Chapter 4
Removal and replacement procedures