HP Pavilion g4-2000 HP Pavilion g4 Notebook PC - Maintenance and Service Guide - Page 74
Remove the Phillips M2.5 × 4.5 screw, Lift the right side of the system board
View all HP Pavilion g4-2000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 74 highlights
Remove the system board: 1. Disconnect the following cables from the system board: (1) Display panel cable (2) optical drive cable (3) USB board cable (4) Power connector cable 2. Remove the Phillips M2.5 × 4.5 screw (1) that secures the system board to the base enclosure. 3. Lift the right side of the system board (2) until it rests at an angle. 4. Remove the system board (3) by sliding it up and to the right at an angle. Reverse this procedure to install the system board. 66 Chapter 4 Removal and replacement procedures
Remove the system board:
1.
Disconnect the following cables from the system board:
(1)
Display panel cable
(2)
optical drive cable
(3)
USB board cable
(4)
Power connector cable
2.
Remove the Phillips M2.5 × 4.5 screw
(1)
that secures the system board to the base enclosure.
3.
Lift the right side of the system board
(2)
until it rests at an angle.
4.
Remove the system board
(3)
by sliding it up and to the right at an angle.
Reverse this procedure to install the system board.
66
Chapter 4
Removal and replacement procedures