HP ProLiant BL660c Configuring Arrays on HP Smart Array Controllers Reference - Page 88

Error code 2829 2830 2831 2832 2833 2834 2836 2837 2838 2839 2841 2842 Error message Comment or clarification Cannot create Array Cannot expand Array Cannot change Array Spare Invalid physical drive Invalid Spare Invalid logical drive New Logical Drive ID does not match the next available logical drive ID. If you are attempting to replicate a configuration that has non-consecutive logical drive numbers, then you must change the script file so that the logical drive numbers are consecutive. New Logical Drive ID already exists Cannot create Logical Drive Cannot migrate Logical Drive RAID Cannot extend Logical Drive Invalid RAID configuration. Configure mode can only create new arrays. The controller will not allow a new array to be created, either because the controller has no unassigned physical drives attached or because the maximum number of arrays or logical drives has been reached already. The Array could not be expanded, either because the controller does not support expansion, or the current configuration does not allow expansion to occur on the array. The spare state of the array could not be changed. This error can occur when you attempt to add or drop a spare and the current configuration does not allow a spare state change for the array. A specified physical drive is not a valid physical drive, or it cannot be placed in the array. A specified spare is not a valid spare drive, or it cannot be placed in the array as a spare. The logical drive ID is not valid. The script file specifies a logical drive ID that is not the first unused ID in the sequence. For example, this message appears if the controller has only Logical Drive 1 and the script file specifies creation of Logical Drive 3 (omitting Logical Drive 2). A common cause of this error is that the input file specifies nonsequential logical drive numbers. In this case, change the logical drive numbers in the input file so that they are sequential. This error occurs in Configure mode when the logical drive ID specified in the script file already exists in the configuration. In Configure mode, you can create new logical drives only. The array has no free space, or the maximum number of logical drives has been reached already. The controller does not support RAID migration, or migration is not possible with the current controller configuration. The controller does not support extension, or the current controller configuration cannot be extended. For example, extension is not possible if the array has no free space. The specified RAID level is invalid or is not possible with the current physical disk and array configuration. HP Array Configuration Utility 88