HP StorageWorks 2/16V Brocade Fabric OS MIB Reference - Supporting Fabric OS 5 - Page 229

connUnitModuleId 1.3.6.1.3.94.1.6.1.19 8 connUnitModuleId 1.3.6.1.3.94.1.6.1.19 This is a unique ID, persistent between boots, that can be used to group a set of connUnits together into a module. The intended use would be to create a connUnit with a connUnitType of "module" to represent a physical or logical group of connectivity units. Then the value of the group would be set to the value of connUnitId for this "container" connUnit. connUnitModuleId should be 0s if this connUnit is not part of a module. Set to the WWN of the switch. connUnitName 1.3.6.1.3.94.1.6.1.20 A display string containing a name for this connectivity unit. This object value should be persistent between boots. Set to switchName/sysName. connUnitInfo 1.3.6.1.3.94.1.6.1.21 A display string containing information about this connectivity unit. This object value should be persistent between boots. For a fabric switch set to sysDescr and read-only. For a Brocade Access Gateway device set to "Access Gateway." connUnitControl 1.3.6.1.3.94.1.6.1.22 Values Controls the addressed connUnit. Each implementation might choose not to allow any or all of these values on a SET. Cold start and warm start are as defined in MIB-II and are not meant to be a factory reset. This is similar to swAdmStatus: resetConnunitColdStart = reboot resetConnunitWarmStart = fastboot offlineConnUnit = disable switch onlineConnUnit = enable switch default after reboot = unknown The declaration 1 (unknown) maps to the default value upon rebooting, and 2 (invalid) is not applicable. Declarations 3 and 4 perform the same operation-a cold boot of the switch. Possible values are: • unknown (1) • invalid (2) • resetConnUnitColdStart (3): Reboot. Performs a switch reboot. Fabric OS MIB Reference 213 53-1000439-01