HP StorageWorks 2/16V HP StorageWorks SAN Switch 2/8V, 2/16V and 2/16N Instal - Page 37
Installing the rear mounting brackets (HP 10000 series or comparable EIA cabinet)
View all HP StorageWorks 2/16V manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 37 highlights
Installing the SAN Switch To install the switch in a rack: 1. Check contents of the shipping carton to verify all the required parts and hardware are available. 2. Choose a mounting location in the rack for the switch. 3. Attach the rear mounting brackets to the rear rack uprights by completing one of the following steps: - For an HP 10000 series or comparable EIA cabinet, assemble each of the two brackets with (2) #10-32 x 1/2-inch Phillips pan-head screws with captive star lock washers and (2) #10 adapter washers as shown in Figure 5. Figure 5: Installing the rear mounting brackets (HP 10000 series or comparable EIA cabinet) - For an HP System/e rack, install each of the two rear mounting brackets with (2) #10-32 x 1/2-inch Phillips pan-head screws and (2) #10 alignment washers as shown in Figure 6. SAN Switch 2/8V, 2/16V and 2/16N Installation Guide 37