HP StorageWorks 2/16V HP StorageWorks SAN Switch 2/8V, 2/16V and 2/16N Instal - Page 90
Serial Port Specifications, The port requires a straight extension serial cable with a female 9-pin
View all HP StorageWorks 2/16V manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 90 highlights
Technical Specifications Serial Port Specifications The serial port is located on the port side of the switch. It is a three-wire RS-232 port with a DB-9 male connector, designed to connect to a DTE port. Note: To provide dust and ESD protection, keep the safety plug on the serial port whenever the port is not in use. The serial port can be used to connect to a computer workstation to configure the switch IP address without connecting to the fabric. The serial port's parameters are 9600 baud, 8 data bits, no parity, 1 stop bit, and no flow control. The port requires a straight (extension) serial cable with a female 9-pin subminiature-D connector. Only pins 2, 3, and 5 are supported. 90 SAN Switch 2/8V, 2/16V and 2/16N Installation Guide
Technical Specifications
90
SAN Switch 2/8V, 2/16V and 2/16N Installation Guide
Serial Port Specifications
The serial port is located on the port side of the switch. It is a three-wire RS-232
port with a DB-9 male connector, designed to connect to a DTE port.
Note:
To provide dust and ESD protection, keep the safety plug on the serial port
whenever the port is not in use.
The serial port can be used to connect to a computer workstation to configure the
switch IP address without connecting to the fabric. The serial port’s parameters
are 9600 baud, 8 data bits, no parity, 1 stop bit, and no flow control.
The port requires a straight (extension) serial cable with a female 9-pin
subminiature-D connector. Only pins 2, 3, and 5 are supported.