HP StoreOnce 4430 HP D2D Backup System Installation and Configuration guide (E - Page 20
Powering on the HP StoreOnce Backup System
View all HP StoreOnce 4430 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
Figure 16 Cabling the Capacity Upgrade Kit to the HP D2D4100 Series Backup System 1. Power connectors 3. Power on/off button 2. P1 connector (on I/O-A) 4. Port 1E connector 4. Power on the Capacity Upgrade Kit. You may need to hold down the power on button for a few seconds. Powering on the HP StoreOnce Backup System NOTE: Ensure that any expansion shelves attached to the system are powered on before pressing the Power button. You may need to hold down the power on button (on the rear of each unit) for a few seconds. Press the Power on button on the front of your HP StoreOnce Backup System. The normal boot sequence takes approximately 2 minutes (5 minutes for the HP D2D4300 Series Backup System). On power up the HP StoreOnce Backup System runs its fans at high speed for approximately 10 seconds before returning to normal speed. Figure 17 Powering on the HP D2D4300 Series Backup System Figure 18 Powering on the HP D2D4100 Series Backup System 20 Connecting and installing the HP StoreOnce Backup System