Hitachi 50HDT50 Owners Guide - Page 39

THE REMOTE CONTROL MODE EXIT MUTE VCR PLUS+ SVCS VID 2 VID 1 USING YOUR REMOTE TO CONTROL ADDITIONAL AUDIO EQUIPMENT VOL TV POWER SLEEP ANT TV/RGB MENU DVD 1 VCR CDSOURCE WIZARDCBL TAPE STB 4 7 2 5 AMP 3 8 6 0 9 A/V NET ASPECT INFO SELECT CH PIP PIP MODE PIP VID 3 CH LAST CH GUIDE/TV VID 4 SWAPPIP ACCESS FREEZE VIDEO SCHD VID 5 REC CLU-5723TSI Operating the precoded function for your Audio component. This remote is designed to operate different types of Audio component. You must first program the remote to match the remote command set of your Audio component (refer to page 40 for pre-codes). 1. Turn ON your Audio component you wish to control with the Remote. 2. Aim the remote control at the front of your Audio component. 3. Press and release the CD, PVR, or AMP button to switch to Audio component pre-coded mode. 4. Hold down the CD, PVR, or AMP button on the remote and enter the two digit preset code that matches your Audio component, as shown on page 40. The CD, PVR or AMP button light will flash 3 times if the code was accepted. 5. Aim the remote at the Audio component and press the POWER button. The remote will turn off your Audio component if the correct two digit preset code is entered. When this occurs, the remote control is programmed for your Audio component. If the Audio component does not turn off, try a different two digit preset code. 6. The remote will now control your Audio component. 7. Repeat steps 1 - 6 if you wish to program the remote to control another Audio component. Be sure to use a different Audio button on the remote, since only one component can be programmed per button. NOTES: 1. If your Audio component cannot be operated after performing the above procedures, your Audio component's code has not been precoded into the remote. 2. In the unlikely event that your Audio component cannot be operated after performing the above procedures, please consult your Audio equipment operating guide. 3. The remote control will remember the codes you have programmed until the batteries are removed from the remote control. After replacing the batteries repeat the entire programming procedure as stated above. ባ POWER TV DVD VCR CBL SOURCE WIZARD CD PVR STB AMP 1 2 3 4 5 6 7 8 9 SLEEP 0 INFO ANT TV/RGB A/V NET ASPECT VIDEO ቢ ቤ ቤ MENU EXIT VOL SELECT CH ቢ CD, PVR, AMP Buttons These buttons allow the remote to control your Audio equipment by setting it to Audio mode. ባ PRECODED AUDIO Buttons These buttons transmit the chosen precoded Audio component codes. ቤ EXCLUSIVE TV Buttons These buttons are for operating the Plasma TV. MUTE LAST CH VID 1 VID 2 PIP VID 3 SURF VID 5 VID 4 FREEZE PIP MODE PIP ACCESS SWAP DAY/NIGHT ባ REC ቤ MY AUDIO EQUIPMENT CODE IS: CD PVR AMP/RCVR NOTE: Refer to instruction manual of the Audio equipment for operation of the buttons exclusively for the Audio equipment. 39