Honeywell WAVE2EX Setup Guide - Page 17
Interactive Menu Mode Programming, Loading Factory Defaults, Pass-Thru Programming
UPC - 781410215504
View all Honeywell WAVE2EX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
LYNXR-I Installation and Setup Guide Interactive Menu Mode Programming (✻56, ✻80, ✻81, ✻83, ✻84, ✻85) Press [✻] + interactive mode No. (i.e., ✻56). The keypad will display the first of a series of prompts. A detailed procedure (with displays of prompts) is provided in later sections of this manual. Interactive Mode Used to Program ✻56 Enhanced Zone Programming Mode Zone characteristics, report codes, and serial numbers ✻80 Device Programming Menu Mode Powerline Carrier Devices ✻81 Zone List Menu Mode Zone Lists for powerline carrier activation ✻83 Enhanced Sequential Mode 5800 Series transmitter serial numbers ✻84 Assign Zone Voice Descriptors Voice descriptors for each zone ✻85 Record Custom Voice Descriptors Up to 5 custom voice descriptors for zones Loading Factory Defaults To load the factory defaults, enter the Programming mode, press ✻97, then press number 1, 2, 3, or 4 to select from default tables 1-4 at the back of this manual, or press "0" if you are not selecting a default table. If a default table is loaded, any data that has already been programmed into the system will be changed according to the default table selected! ✻96 resets all subscriber account numbers and CSID in preparation for an initial download. Exiting Program Mode ✻98 inhibits re-entry into the Expert or Voice Prompt Programming modes using the Installer Code. ✻99 allows re-entry into the Expert Program mode using Installer Code (4112) + 800 or into the Voice Prompt Programming mode using Installer Code (4112) + 888. Note: After exiting program mode (or upon power-up), the system takes up to a minute to reset. To bypass the reset delay, press [#] + [0]. Pass-Thru Programming This mode allows the Installer to use the LYNXR-I keypad and display to program the communications device that is connected to the LYNXR-I. Refer to the communications device's installation instruction to determine whether this feature is supported. Entering Pass-Thru Programming mode 1. After power-up, enter the Installer Code (4112) + 899. 2. Once you have entered Pass-Thru Programming mode "PtP" will be displayed on the keypad. 3. Refer to the Installation Instructions for the LRR/IP Communications Device being installed for additional programming information. LYNXR-I will abort this mode: • When it receives an abort command from the new communications device. • If it fails to communicate with an communications device after 20 attempts. • 30 minutes after the last key has been pressed. - 17 -