Honeywell WAVE2EX Setup Guide - Page 45

LYNXR-I Installation and Setup Guide Voice Prompt Programming Enter Voice Prompt Programming Mode: (Installer Code + 8 8 8). Follow the voice prompts to advance to the selected item in the Main Programming Menu. Add Sensors First Central Station Phone Number Second Central Station Phone Number Templates Delete Sensors First Central Station Account Number Second Central Station Account Number Expert Programming Mode Program each option as shown below. Use the 6 ↓ and 3 ↑ keys to scroll through the voice menu and follow the voice prompts to program the LYNXR-I. ! The LYNXR-I will enroll a sensor once the transmitter has been activated two times. The system will confirm the enrollment following each subsequent activation of the same transmitter. To Add a Door Sensor Select "Add Sensors" Press [SELECT] Select "Delay Door" Press [SELECT] Select delay door location 5AA  Press [SELECT] (1) Delay Door Location Front Basement Back Sliding Side Hall Garage Kitchen Patio Activate transmitter twice System announces descriptors for the programmed sensor Press [ADD] To add a Window, Motion Detector, or Fire Detection Sensor Select "Add Sensors" Select sensor type See (2) Select sensor location See (3) To add modifier Select location modifier See (4) Activate transmitter twice System announces descriptors for the programmed sensor Press [SELECT] Press [SELECT] Press [SELECT] Press [SELECT] Press [SELECT] Press [ADD] OR To enroll transmitter (2) Sensor Type Window Motion Detector Fire Detection (3) Sensor Location Living room Dining room Bedroom Bathroom Nursery Kitchen Hall Basement Master Bedroom Den Family Room Guest Room Laundry Room Utility Room Garage Attic Office Upstairs Activate transmitter twice System announces descriptors for the programmed sensor Press [ADD] (4) Location Modifiers Upstairs Downstairs First Second Third Second Floor Front Rear Side - 45 -