Honeywell WAVE2EX Setup Guide - Page 51

LYNXR-I Installation and Setup Guide System Operation Keypad Functions The keypad allows the user to arm and disarm the system, and perform other system functions, such as bypassing zones. Zone and system conditions (alarm, trouble, bypass) are displayed in the display window. When an alarm occurs, keypad sounding and external sounding will occur, and the zone(s) in alarm will be displayed on the keypad. Pressing any key will silence the keypad sounder for 10 seconds (only once). Disarming the system will silence both keypad and external sounders. When the system is disarmed, any zones that were in an alarm condition during the armed period will be displayed (memory of alarm). To clear this display, simply repeat the disarm sequence (enter the security code and press the OFF key). The keypad also features chime annunciation, and 3 panic key pairs for silent, audible, fire or personal emergency alarms. These keys can notify the central station of an alarm condition, if that service is connected. A summary of system functions is provided below for more detailed information refer to the User's Manual. Security Functions (Empty boxes represent the user's security code) Checking system status STATUS (high level messages); press STATUS again for secondary messages To arm in STAY mode + STAY (or installer code + [3]) To restart exit delay STAY (applies only if system is armed in Stay mode) To arm in AWAY mode + AWAY (or installer code + [2]) To arm with NO DELAY + AWAY or STAY + NO DELAY To arm if Quick Arm is programmed: .. AWAY or STAY (hold down for at least 2 seconds) To disarm the system and silence alarms: + OFF Note: During Exit Delay or when an Alarm Condition exists the system can be disarmed by entering the User Code and entering the OFF key is not required. To bypass a zone(s + BYPASS + 2-digit zone number(s) To turn Chime mode on or off FUNCTION + CHIME Message Center To record a message FUNCTION + RECORD To stop recording before end of 90 seconds: OFF To play back a message FUNCTION To skip a message To delete all messages FUNCTION + PLAY + DELETE (during message replay) Volume Control To adjust message playback/system announcement volume: FUNCTION + VOLUME + [3] or [6] To mute system announcements: ......... FUNCTION + VOLUME + OFF To restore/unmute announcement & volume: FUNCTION + VOLUME + [3] or [6] Other Functions To set the time and date + FUNCTION + [63] To set the scheduling + FUNCTION + [64] To activate or deactivate X10 devices 1-6: FUNCTION + LIGHTS ON or LIGHTS OFF + device number To activate or deactivate X10 devices 7 & 8: + FUNCTION + LIGHTS ON or LIGHTS OFF + dev. No. To add a user code To delete a user code (except Master Code): *+ CODE + user number + user's code (*master code) *+ CODE + user number (* master code) To turn Test mode on + TEST To turn Test mode off + OFF - 51 -