Honeywell WAVE2EX Setup Guide - Page 9
Connecting AlarmNet 7845GSM* / 7845i-GSM, Connecting AlarmNet 7845i-ENT/7845i
UPC - 781410215504
View all Honeywell WAVE2EX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
LYNXR-I Installation and Setup Guide AlarmNet 7845GSM*, 7845i-GSM*, 7845i-ENT or 7845i, Communications Device The 7845i-ENT/7845i and 7845CV2 can not be used for installations requiring 24-hour standby. 1. Connect the 4-wire communications cable to the LRR/IP Communications port on the LYNXR-I. 2. Connect the four wires to the specific Communications device as shown in the accompanying figures. 3. If you are installing a 7845GSM or 7845i-GSM you must also install a jumper between terminals 2 and 3 on the communications device. 4. Connect the device to the Internet via a cable/DSL modem and router or to an Intranet (LAN) via the appropriate Ethernet connection, if applicable. YEL RED BLK GRN 4-WIRE CABLE (N4632-4) LRR/IP COMMUNICATIONS PORT RED BLK YEL GRN TB1 1 2 43 ECP (+) VOLTAGE INPUT 4 GND 5 Z1/Z2 OR DATA IN 6 Z3 OR DATA OUT DATA OUT NC +12 VDC GND DATA IN LYNXR-I CONTROL PANEL 7845GSM / 7845i-GSM LYNX STANDARD CAPACITY BATTERY LYNX SUPER HIGH CAPACITY (OPTIONAL) REQUIRED FOR BATTERY 24-HR BACKUP Connecting AlarmNet 7845GSM* / 7845i-GSM* 7845i-GSM-010-V0 * When available. The AlarmNet 7845GSM and 7845i-GSM modules have not been evaluated by UL. 4-WIRE CABLE (N4632-4) 7845i-ENT / 7845i (+) VOLTAGE INPUT GND DATA OUT DATA IN YEL RED BLK GRN DATA OUT NC +12 VDC GND DATA IN TB 1 RED BLK GRN YEL LRR/IP COMMUNICATIONS PORT LYNXR-I CONTROL PANEL RED BLK GRN YEL LYNX STANDARD CAPACITY BATTERY Connecting AlarmNet 7845i-ENT/7845i 07000-013-V2 - 9 -