Honeywell WAVE2EX Setup Guide - Page 35
Programming Powerline Carrier Devices
UPC - 781410215504
View all Honeywell WAVE2EX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 35 highlights
LYNXR-I Installation and Setup Guide ✻80 Device Programming Menu Mode STOP The "STOP" programming determines when and under what conditions the device will be deactivated. The following options are available: Upon Restore of a Zone List Restore Zone List: If a "ZONE LIST" is used as the "Stop" event, the device will de-activate when all the zones in that list restore from a previous fault, trouble, or alarm condition. This will occur regardless of what is programmed to "START" the device; therefore, a "RESTORE ZONE LIST" would normally only be used when a "ZONE LIST" is used to start the device. Upon a Zone Type or System Operation Zone Type/System Operation: Instead of using a "RESTORE ZONE LIST," a specific zone (response) type or system operation action can be selected to de-activate the device. • If a specific "ZONE TYPE" is chosen, any zone of that response type that restores from a previous alarm, trouble, or fault condition will cause the device to de-activate. • If a "SYSTEM OPERATION" is chosen, that operation will cause the device to de-activate. During normal system operation, any devices may be manually started by keypad entry of: Code* + [#] + 4 + "n;" or manually stopped by keypad entry of: Code* + [#] + 7 + "n," where "n" = the device number to be controlled. * Code is required for devices 7 and 8. For devices 1-6, code is not required. See User Manual for more information. Programming Powerline Carrier Devices While in program mode, press ✻80 to enter Output Device Menu Mode. This mode is used to program all output devices used in the system. Refer to the output device table for ✻80 on the separate programming form when programming output devices. Note: The House ID of the Powerline Carrier Devices must be entered in data field ✻25. The prompts for ✻80 are as follows: 80 Powerline Carrier Device Programming Main Menu prompt A 01 Device Number --------- for entering the device number b Device Action for defining the action the device will perform when active C Start Event Type ------- for assigning the event type to start the action d Start Zone List ---------- for assigning the zone list to start the action E Start Zone Type--------- for assigning the zone type to start the action F Stop Zone List for assigning the zone list to stop the action 1A Stop Zone Type---------- for assigning the zone type to stop the action - 35 -