Honeywell WAVE2EX Setup Guide - Page 52
Remote Phone Control Feature, Keypad Functions
UPC - 781410215504
View all Honeywell WAVE2EX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 52 highlights
LYNXR-I Installation and Setup Guide System Operation To use the defined AUX function: Press and hold AUX key 2 secs (4 beeps) + To define AUX function: + FUNCTION + AUX + action separated by + AUX terminated by + AUX + AUX To send message to pager: Press and hold AUX key 2 seconds (4 beeps) To program Follow Me Announcement telephone number: + FUNCTION + [65] Speaker Phone Operation To place a call or answer a call using the speaker phone: [#] + AUX To flash (switch between two calls using call waiting): AUX NOTE The ARMED and READY LEDs blink alternately when the Speaker Phone is active. To hang up and exit speaker phone mode: OFF To enable/disable (toggle) ringer: [#] + VOLUME + AUX To return the keypad to telephone mode after disarming the system: [#] + AUX Remote Phone Control Feature The remote phone control feature, which must be enabled in field ✻91, allows the user to access the security system from any off-site touch-tone telephone. The control will pick up the incoming call, based on the ring count specified in field ✻95, and will announce "SYSTEM ENTER CODE" every three (3) seconds for the next eight (8) seconds. During this period the panel will wait for a valid User Code to be entered. If a valid User Code is not entered or the eight (8) second period expires a modem tone will be generated for remote programming (Compass Downloading). If a valid User Code has been entered, the control will announce the current system status and/or beeping sounds. Keypad Functions Remote Phone Control Feature To remotely disarm system: To remotely arm in AWAY mode: To remotely arm in STAY mode: + [1] + [2] + [3] Quick Arm Note The installer code and babysitter code cannot disarm the system if armed by Quick Arm method. To remotely arm in AWAY or STAY with no delay: + [2] or [3] + [0] To remotely activate X10 devices 1-6: [#] + [4] + device no. To remotely activate X10 devices 7 & 8: + [#] + [4] + device no. To remotely deactivate X10 devices 1-6: [#] + [7] + device no. To remotely deactivate X10 devices 7 & 8: + [#] + [7] + device no. To remotely Bypass zones: + [6] + zone no. To remotely activate Forced Bypass: + [6] + [#] To remotely check system status: [✻] To end remote phone control session: Hang Up or enter + [9] - 52 -