Honeywell WAVE2EX Setup Guide - Page 5
Mounting the Control - lynx
UPC - 781410215504
View all Honeywell WAVE2EX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
LYNXR-I Installation and Setup Guide Mounting the Control Wall Mounting The illustration below shows the front assembly separated from the back plate. DO NOT disconnect the ribbon cable from the terminal strip board. Disconnect the cable only from the front assembly board. 1. Release the front assembly from the back plate by depressing the two locking tabs at the top of the unit with the blade of a medium size screwdriver. 2. Once these tabs have been released, insert the screwdriver in the side of the case and release the side locking tabs by gently twisting. 3. Carefully disconnect the ribbon cable from the front assembly, leaving the ribbon cable connected to the terminal block PC board. The back plate contains the terminal block for making wiring connections. 4. Mount the back plate to a sturdy wall, feeding the field wiring through the appropriate openings in the back plate. 5. After wiring connections are made, carefully reconnect the ribbon cable to the front assembly PC board connector (properly aligning the red wire). 6. Snap the front assembly to the back plate so it is secured by the locking tabs. LOCKING TABS LOCKING TABS RED WIRE MARKING DISCONNECT THIS END ONLY! LOCKING TABS 07000-003-V1 Desktop Mounting For desktop use the optional mounting base (model LYNX-DM, purchased separately) must be used. 1. Slide the control panel onto the mounting base locking tabs. 2. Bring all wiring through the bottom of the mounting base, using one of the three wire entry locations, before making connections to the control panel. 3. Use tie-wraps to secure the wiring to the built-in wire loops as needed. Use the two supplied screws to secure the control panel to the mounting base. OFF ESCAPE AWAY ADD STAY DELETE AUX SELECT WIRE ENTRY KNOCKOUT (1 of 3) 01009-004-V1 - 5 -