Husqvarna AUTOMOWER 310 Owner Manual - Page 18
To put the boundary wire in a slope, Passages, To make an island, 15 cm / 0-6, cm / 40
View all Husqvarna AUTOMOWER 310 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
0-15% 35 cm / 14" > 5 cm/>2" • Put the boundary wire 30 cm / 12 in. (C) from an obstacle that is 1-5 cm / 0.4-2 in. high. • Put the boundary wire 10 cm / 4 in. (D) from an obstacle that is less than 1 cm / 0.4 in. • If you have a paving stone path that is in level with the lawn, put the boundary wire below the paving stone. Note: If the paving stone is minimum 30 cm / 12 in. wide, use the factory setting for the Drive Past Wire function to cut all the grass adjacent to the paving stone. CAUTION: Do not let the product operate on gravel. • If you make an island, put the boundary wire that runs to and from the island near together (E). Put the wires in the same stake. • Make an eyelet (F) where the guide wire is to be connected to the boundary wire. CAUTION: Do not make sharp bends when you install the boundary wire. CAUTION: For careful operation without noise, isolate all obstacles such as trees, roots and stones. 3.3.3.1 To put the boundary wire in a slope The product can operate in slopes. Slopes that are too steep must be isolated with the boundary wire. The gradient (%) is calculated as height per m. Example: 10 cm / 100 cm = 10%. 100 cm / 40" 0-15 cm / 0-6" • For slopes steeper than 25% inside the work area, isolate the slope with boundary wire. • For slopes steeper than 10% along the outer edge of the lawn, put the boundary wire 20 cm / 8 in. (A) from the edge. >15% A • Slopes adjacent to a public road must be isolated with boundary wire. Put a fence or a protective wall along the outer edge of the slope. 3.3.3.2 Passages A passage is a section that has boundary wire on each side and that connects 2 work areas. The passage must be a minimum of 60 cm / 24 in. wide. Note: If a passage is less than 2 m / 6.5 ft. wide, install a guide wire through the passage. 3.3.3.3 To make an island • Put the boundary wire to and around the obstacle to make an island. • Put the 2 sections of boundary wire that run to and from the obstacle together. • Put the 2 sections of boundary wire in the same stake. 18 - Installation 1220 - 001 - 08.07.2019