Icom IC-SAT100M Basic Manual eng/ger/esp/fra/ita - Page 3
Precautions, ENGLISH
View all Icom IC-SAT100M manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
ENGLISH ■■ Precautions DDFor the transceiver RRWARNING! NEVER operate the DO NOT place or leave the transceiver in excessively dusty environments. 1 transceiver during a lightning storm. It may DO NOT place the transceiver against walls. 2 result in an electric shock, cause a fire or Otherwise heat dissipation will be obstructed. damage the transceiver. Always disconnect the power source and antenna before a DO NOT use harsh solvents such as 3 storm. Benzine or alcohol when cleaning, as they RRWARNING! NEVER place the damage the transceiver's surfaces. transceiver where normal operation of the Keep the transceiver away from the heavy vehicle may be hindered or where it could rain, and never immerse it in the water. cause bodily injury. The transceiver meets IP54(main unit)* / RRWARNING! Immediately disconnect the AC adapter if the transceiver emits an abnormal odor, sound or smoke. Contact your Icom dealer or distributor for advice. IP55 (microphone) / IP67 (antenna unit) requirements for dust-protection and splash resistance. However, once the transceiver has been dropped, dust protection and splash resistance cannot be guaranteed CAUTION: NEVER connect the transceiver due to the fact that the transceiver may be to a power source of more than 32 V DC. cracked, or the waterproof seal damaged, This could damage the transceiver. and so on. *Only when the microphone is attached. CAUTION: NEVER cut the DC power cable between the DC plug and fuse holder. If an incorrect connection is made after cutting, the transceiver might be damaged. Use the specified microphone only. Other microphones have different pin assignments and may damage the transceiver. CAUTION: Confirm that all connectors and jacks are dry and clean before attachment. Exposing them to dust or water will result in serious damage to the transceiver. In some countries, using a satellite communication device may be prohibited, or a license is required. Make sure you comply with all applicable laws and CAUTION: The Antenna unit will become regulations in your area. hot when operating continuously for long periods. NEVER place the transceiver in an insecure place to avoid inadvertent use by unauthorized persons. DO NOT place or leave the transceiver in areas with temperatures below -30°C (-22°F) or above +60°C (+140°F), or in areas subject to direct sunlight, such as the dashboard. DO NOT operate the transceiver without running the vehicle's engine. The vehicle's battery will quickly run out when the transceiver transmits while the vehicle's engine is OFF. 2