Intermec CS40 Intermec Terminal Emulator (ITE) User Guide - Page 71

Chapter 2 - Configuring and Managing ITE Selecting a Printer You can select a printer for each of the four sessions. The printer can be on your network, or connected to the computer through IrDA, Bluetooth, or a serial port. To select a printer 1 Open the Intermec Terminal Emulation main menu in Intermec Settings. For help, see "To configure ITE directly on the computer" on page 21. 2 Tap Session 1, Session 2, Session 3, or Session 4. The list of configuration items for that session appears. 3 Tap Print Device. Note: Print device options will differ depending on your Intermec computer. 4 Select one of the options: • Tap RS232 Print for the RS-232 print driver. This setting is the default for the CV41 and CV61. • (CK70, CK71, CN70 only) Tap IRDA Print or press 2 to select an IrDA printer connection. • Tap Network Print to select a network printer. • Tap Bluetooth Prt to select the current Bluetooth printer. This setting is the default for the CK3, CK70, CK71, CN3, CN4, CN50, CN70, and CS40 computers. Note: ITE only supports Bluetooth devices connected to COM6. 5 Tap OK to save your changes and return to the LCD Parms list, or tap Cancel to return to the Print Device list without saving any changes. 6 If you chose IrDA Print, RS232 Print, or Bluetooth Prt, ITE is ready to print to the printer connected to the computer by that method. Before you try to print, make sure you have a valid connection to your printer. If you chose Network Print, you need to specify the printer IP address and printer port. For more information, see "Configuring a TCP/IP Connection" on page 25. Intermec Terminal Emulator (ITE) User Guide 59