JVC DLA-G20U DLA-G20U User instruction manual (2.6MB) - Page 27

Basic Operations s Projector's buttons STAND BY STAND BY indicator OPERATE indicator LAMP TEMP EMERGENCY VIDEO COMPUTER SETTING +3 QUICK ALIGN -2 OPERATE button 2, 1 1, 2 MAIN POWER switch The following describes the basic procedure for normal use of the projector. 1. Turning on the Power 1 Turn on the MAIN POWER switch. ON [ ƒ ]:The main power turns on and the STAND BY indicator comes on. Projector's indicator STAND BY (ON) 2 Press the OPERATE button for one second or more. • The OPERATE indicator comes on. • About 30 seconds after the MAIN POWER switch is turned on, you can start projecting. Remote control unit OPERATE or Projector (ON) OPERATE s Remote control unit OPERATE COMPUTER VIDEO Touche OPERATE 2, 1 VOL. PAGE BACK T ZOOM W FOCUS MENU/ENTER PRESET QUICK ALIGN. AV MUTING Notes • After the power is turned on, the screen may be jumbled for a few seconds, but this is not a malfunction. • If the light-source lamp does not light up, try to press the OPERATE button for more than a second again. s Turning off the Power 1 Press the OPERATE button for one second or more. • The STAND BY indicator changes to blinking, and the projector goes into cool-down mode. Example of the projector's button Projector (ON) OPERATE (Blinking) \ STAND BY 2 Turn off the MAIN POWER switch after the STAND BY indicator changes to steady on. OFF [‡]: The MAIN POWER switch turns off and the STAND BY indicator goes off. Projector (OFF) STAND BY * Do not turn off the MAIN POWER switch during cool down mode (the STAND BY indicator blinking). Turn it off after the STAND BY indicator becomes on (standby mode). 26