JVC DLA-G20U DLA-G20U User instruction manual (2.6MB) - Page 61
Replacing the Fuse
View all JVC DLA-G20U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 61 highlights
Replacing the Fuse A fuse is used to protect the power source of the projector. If the fuse is burned out, replace it. When the power switch is turned on but no power is supplied to the projector, check the fuse. When replacing the fuse, obtain the same type of fuse rated 15A/250V. If there are any unclear points, contact the dealer where you purchased your projector. 1 Turn off the main power switch and disconnect the power cord from both the projector and the wall outlet. Place the main power switch to the OFF [‡] position. 2 Loosen the fuse holder to remove it. To loosen the fuse holder, use a Philips screwdriver. 3 Remove the fuse from the fuse holder you just removed. 4 Installthenewfuseintothefuse holder . 5 Reinstallthefuseholderintothe projector . Fuse holder Philips screwdriver Fuse (15A, 250V) Fuse holder Fuse (15A, 250V) Fuse holder 60