JVC DLA-G20U DLA-G20U User instruction manual (2.6MB) - Page 63
inside and fasten the screws.
View all JVC DLA-G20U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 63 highlights
Replacing the Light-Source Lamp (Cont.) 2 Loosen the lamp-unit screws, raise the handle, and pull out the lamp unit. Loosen the two screws with a flat-end screwdriver. Note • The screws are fitted so that they do not come off the lamp- unit. 3 Insert the new lamp unit fully inside and fasten the screws. Fasten the two screws with a flat-end screwdriver. CAUTION • Do not touch the glass surface of the light-source lamp directly with your hand as well as staining it. If you touch with a bare hand, stains on your hand may adhere to the lamp, possibly preventing the lamp from performing as specified due to a shortened lamp life, a darkened screen, etc. To handle a new light-source lamp, hold its plastic part. Never touch the metal part or the front glass surface. Screw Lamp unit 2 1 Handle Lamp unit 1 2 Handle Screw 4 Replace the lamp-replacement opening cover and fasten the screws. Fasten the two screws with a flat-end screwdriver. Lamp-replacement opening cover Be careful not to damage the claw. CAUTIONS • Install the lamp unit and close the lamp-replacement opening cover correctly; otherwise, a safety switch is activated to prevent the projector from operating. • If the claw on the lamp-replacement opening cover is damaged, the projector may not possibly operate. Then, replace with a new lamp-replacement opening cover. • After replacing the lamp, be sure to reset the lamp use time (see page 63). 62