JVC RMP-2580U RM-P2580 Dome Controller Instructions (1148KB) - Page 5
JVC RMP-2580U - Remote Controller For Color Domes Manual
View all JVC RMP-2580U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
1. INTRODUCTION CONTROLS, CONNECTORS AND INDICATORS [Control Panel] 1 2 3 45 6 7 REMOTE CONTROL UNIT RM-P2580 CAMERA POSITION SETUP POWER SET MENU ALARM KEY LOCK AUTO F-1 F-2 F-3 LENS SPEED CAMERA/POSITION PAN/TILT POSITION 1 OPEN 2 5 8 0 /HOME 3 6 9 ENTER CAMERA CLOSE IRIS 4 7 CLEAR OPTION 1 OPTION 2 NEAR FOCUS AF FAR AUTO PAN AUTO PATROL WIDE ZOOM TELE 1 [MENU] button (with an indicator) When this button is pressed, the MONITOR OUTPUT 1 , on the rear panel outputs a menu screen and the indicator with this button lights up. REF. : "MENU SCREEN SETUP" on page 25. 4 [POWER] indicator This indicator lights up when the POWER switch fi on the rear panel is set to ON. 5 [KEY LOCK] indicator This indicator lights up when the unit is in the KEY LOCK status. REF. : "2 [SET] button" for the KEY LOCK status setting. 2 [SET] button ● While a normal screen is displayed (i.e. when a menu screen is not displayed), pressing and holding this button for more than 3 seconds generates a short beep, lights up the KEY LOCK indicator 5 and then puts the unit to the KEY LOCK status. In the KEY LOCK status, all buttons as well as the PAN/ TILT control lever # on the control panel are inactive. To release the KEY LOCK status, press and hold the SET button again for more than 3 seconds. ● While a menu screen is displayed, this button is used to display a menu in a lower hierarchy level or to enter a setting. REF. : "MENU SCREEN SETUP" on page 25. 6 [CAMERA] display Shows the camera number of the camera signals output from the MONITOR OUTPUT 1 connector , . REF. : "CAMERA SELECTION" on page 10. 7 [POSITION] display Shows the position number of the camera signals output from the MONITOR OUTPUT 1 connector , . REF. : "POSITION SELECTION" on page 11. 3 [ALARM] indicator This indicator blinks when an alarm signal is input. REF. : "ALARM OPERATION" on page 17. 5