Kenmore 4031 Use and Care Guide - Page 28
Close the water taps, unplug the washer, and call for service.
View all Kenmore 4031 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
BEFORE CALLING FOR SERVICE (cont.) The display shows: I Check if... u# #,I-:| Then... Load is too small. Load is out of balance. Add 1 or 2 similar items to help balance the load. Pause the cycle and redistribute the load after the door unlocks. The washer has an imbalance detection and correction system. If individual heavy articles are loaded (bath mat, bath robe, etc.) and the imbalance is too great, the washer will make several attempts to restart the spin cycle. If an imbalance is still detected, the washer wilt stop and the error code wilt be displayed. The display shows: I Check if... Control error. _L'_-I Then... Unplug the washer and wait 60 seconds. Reconnect power and try again. If the error reappears, call for service. The display shows: Check if... Ir-I-J- - | Water level is too high due to a faulty water valve. The display shows: In-I_--- Check if... The water level sensor is not working correctly. The display shows: LnLn-"- Check if... Thermal overload protection circuit in the motor has been tripped. I The display shows: PF Check if... A power failure has occurred. Then... Close the water taps, unplug the washer, and call for service. [ I Then... Close the water taps, unplug the washer, and call for service. [ I Then... Allow the washer to stand for 30 minutes to allow the motor to coot; then restart the cycle. If the LE error code persists, call for service. Then... If the power to the washer has been interrupted during a cycle, the "PF" error code wilt be displayed the next time the washer is turned ON. This wilt alert you to the fact that the previous cycle may not have been completed. Select any cycle to clear the error code and use the washer. 28